B00E2 medium Severity

B00E2: Third Row Center Seatbelt Pretensioner B Deployment Control (Subfault)

May illuminate airbag/seatbelt warning; no direct engine drivability impact but affects occupant safety restraint system

Overview

B00E2 indicates a fault in the third row center seatbelt pretensioner B deployment control circuit detected by the vehicle restraint control module.

Common Symptoms

  • Airbag or seatbelt warning light illuminated
  • Diagnostic trouble code stored for restraint system

Most Common Causes

Faulty third row center seatbelt pretensioner B medium

Component may have an electrical fault or be damaged

Open or shorted wiring in pretensioner B circuit medium

Connector issues or wire harness damage can trigger this code

Poor electrical connection at pretensioner module medium

Corrosion or loose pins may cause intermittent detection

Diagnostic Steps

  1. Retrieve code and freeze frame data with advanced scan tool
    Expected: B00E2 present with DTC description relating to third row center seatbelt pretensioner B
    Interpretation: Confirms specific fault code and any related status bytes
  2. Visually inspect wiring and connectors for pretensioner B circuit
    Expected: No damaged wires, secure connectors, no corrosion
    Interpretation: If issues found, repair wiring/connectors and re-test
  3. Measure continuity and resistance of pretensioner B harness to control module
    Expected: Continuity within specification without short to ground or power
    Interpretation: Out-of-spec readings indicate harness fault
  4. Test pretensioner B component per manufacturer procedures
    Expected: Component tests within OEM-defined resistance and response
    Interpretation: Failure suggests pretensioner assembly replacement

Repair Solutions

Repair or replace damaged wiring/connectors in pretensioner B circuit medium
Estimated Cost: $50 - $300

Cost depends on extent of wiring damage

Replace third row center seatbelt pretensioner B assembly hard
Estimated Cost: $200 - $800

Part cost varies; may require professional installation due to safety system involvement

Clean and secure electrical connectors easy
Estimated Cost: $0 - $50

Basic maintenance step before component replacement

Common Misdiagnoses

Avoid these common diagnostic mistakes:

  • Misidentifying as general airbag system fault rather than specific pretensioner circuit
  • Assuming ECM/PCM fault instead of restraint control wiring issue

Frequently Asked Questions

Technical definition of B00E2 OBD-II Code

The B00E2 code stands for Third Row Center Seatbelt Pretensioner B Deployment Control (Subfault). This generally indicates an issue with the Sensors system.

Can B00E2 cause engine damage?

You should treat B00E2 as a medium issue. May illuminate airbag/seatbelt warning; no direct engine drivability impact but affects occupant safety restraint system

How do I know if I have code B00E2?

The most typical signs are: Airbag or seatbelt warning light illuminated, Diagnostic trouble code stored for restraint system.

Why is my car throwing a B00E2 code?

It can be caused by several factors, most notably: Faulty third row center seatbelt pretensioner B, Open or shorted wiring in pretensioner B circuit, Poor electrical connection at pretensioner module.

What is the price difference for fixing B00E2?

Expect to pay around $50 if the issue is a Clean and secure electrical connectors, but up to $800 if the Replace third row center seatbelt pretensioner B assembly needs replacement.

What cars are affected by the B00E2 code?

The B00E2 code is a generic powertrain code, meaning it applies to almost all makes and models, such as Honda, Toyota, VW, Ford, and Chevy.

User Comments (0)

Share your experience or ask a question about this code.

Be the first to share your experience with B00E2!