B00C2
medium Severity
B00C2: Passenger Seat Occupant Classification Sensor C (Subfault)
May illuminate airbag/vehicle safety light; does not typically affect engine or drivability but impacts occupant safety system behavior
Overview
OBD‑II trouble code B00C2 indicates a fault with the passenger seat occupant classification sensor C, part of the occupant classification/airbag suppression system.
Common Symptoms
- Airbag warning light illuminated on instrument cluster
- Possible passenger airbag disable/incorrect status indication
Most Common Causes
Faulty passenger seat occupant classification sensor C
medium
Sensor itself may have failed or be out of spec.
Open or shorted harness to sensor C
medium
Wiring issues causing intermittent or no signal.
Poor electrical connection at sensor circuit
medium
Corroded connector or pin contact issues.
Faulty airbag/occupant classification control module
low
Module that reads sensor input may be defective.
Diagnostic Steps
-
Verify fault code presence and freeze frame data with OBD‑II scannerExpected: B00C2 present as stored or pending codeInterpretation: Confirms issue is recurring and logged.
-
Inspect physical connector and wiring harness for sensor C for damage, corrosion, or disconnectionExpected: Wiring intact with secure connectorInterpretation: If wiring is damaged or connector loose, this is likely cause.
-
Perform continuity and resistance checks on sensor C circuitExpected: Continuity within service spec and no shorts to ground or batteryInterpretation: Faulty electrical path indicates wiring/connector repair needed.
-
Replace passenger seat occupant classification sensor C if wiring and connectors are goodExpected: Code should clear and not return post replacementInterpretation: Replacement of sensor resolves fault if issue internal to sensor.
-
If sensor and wiring are good, test/replace airbag/occupant classification control moduleExpected: Code no longer sets after module replacementInterpretation: Control module failure is less common but possible.
Repair Solutions
Repair or replace damaged wiring/connector for sensor C
medium
Estimated Cost: $50 - $200
Costs vary based on labor and whether aftermarket parts are used.
Replace passenger seat occupant classification sensor C
medium
Estimated Cost: $200 - $600
Sensor cost varies by OEM and model; labor required to access seat electronics.
Replace airbag/occupant classification control module
hard
Estimated Cost: $300 - $1000
Module replacement is expensive; ensure diagnosis confirms module failure.
Common Misdiagnoses
Avoid these common diagnostic mistakes:
- Assuming general airbag system fault unrelated to occupant classification sensor wiring
Frequently Asked Questions
Technical definition of B00C2 OBD-II Code
The B00C2 code stands for Passenger Seat Occupant Classification Sensor C (Subfault). This generally indicates an issue with the Sensors system.
Is it safe to drive with a B00C2 code?
This is a medium priority issue. May illuminate airbag/vehicle safety light; does not typically affect engine or drivability but impacts occupant safety system behavior
How do I know if I have code B00C2?
You may experience the following: Airbag warning light illuminated on instrument cluster, Possible passenger airbag disable/incorrect status indication.
What causes the B00C2 code?
This code is frequently triggered by: Faulty passenger seat occupant classification sensor C, Open or shorted harness to sensor C, Poor electrical connection at sensor circuit.
Is B00C2 expensive to fix?
Expect to pay around $200 if the issue is a Repair or replace damaged wiring/connector for sensor C, but up to $1000 if the Replace airbag/occupant classification control module needs replacement.
Is B00C2 a generic or manufacturer-specific code?
B00C2 is not specific to any one brand. It can appear on Ford, Dodge, Toyota, Honda, Jeep, and other vehicles.
User Comments (0)
Share your experience or ask a question about this code.
Please login to post a comment.
Be the first to share your experience with B00C2!